Medium Voltage sockets with solid insulator mediums in every phase
Low Voltage sockets in aluminium plates treated for coupling with
copper bars.
Horizontal towing hooks and eye bolts for lifting
Voltage Change Clamps with control fields ± 2x2.5% to operate when
the transformer is off load / not energised.
Run Routes which can be oriented at 90°
Grounding connectors
Identification Tag to IEC standards
Accessories upon Request
Plug connections on medium voltage side up to 36 KV and maximum
current 400 A.
Medium voltage side protection using cover caps to avoid accidental
contact and prevent dust and other particles in the environment from
depositing on the MT tangs.
Protection of voltage change clamps.
Rubber supports to reduce phenomena caused by vibrations transmitted
by metallic structures and noise (anti vibration pads).
Forced air ventilation systems to increase the nominal power up to
35%.
Protective containers from IP20 or IP23 to IP31
Supplementary probes equipped with sensors to check the temperature
of the windings of the transformer.
Electrostatic monitor between primary and secondary (accessory made
specifically for transformers which feed systems using cc)
Control equipment to visualize temperature readings to be installed
on the switchboard. By means of this equipment it would be possible
to program the two temperature values corresponding to predefined
alarm levels and disconnection according to the thermal category of
the insulation material. It would also be possible to program a
forced cooling intervention, if necessary.
Medium Voltage sockets with solid insulator mediums in every phase
